Info on tuning box? Performance Chips It is possible to buy performance chips that you can install in your car yourself or specialist companies offer a replacement service where they supply and fit the performance chip. These are often off the shelf maps designed to suit a wide range of cars. They do offer benefits over standard but as with all generic mods, they can never compete with a custom map designed specifically for your car and driving style. We are often asked if chip tuning works on all engines.

Now therefore the step to be performed is to purge the old data and reset your ECU. Doing this allows it to adapt itself to new parts and efficiently perform post modification also. To reset the ECU you simply have to unplug the negative battery cable connection. Theoretically it is best to leave it in this disconnected condition for as long as you can. Practically leaving it disconnected overnight is more than enough. After having left the cable disconnected for sufficient time you have to connect back the cable. Start the car and keep it running so that it warms up. This would not take more than 10 minutes at the most in summers. Once you have done this you have accomplished the ECU resetting. Shut off the engine. Read more info on centralina Drakebox.

One only wonders why most used keyword in Google is “dual-mass, flywheel,clutch,chiptuning,dead,destroyed,help”. Albert Einstein once said “Human stupidity and Universe is infinite…” Chiptuning companies protect themselves with cunning agreements such as “don’t use full load flat out all the time, only for overtaking” and so on. Excuse, incompetence or just no balls to take responsibility in your hands…but I don’t wonder, it goes both ways…poor maintenance is common among most drivers and “it is your fault” syndrome is most deadly force in modern civilization…Albert told you so !!! Destroyed clutch is common result of chiptuning and even worst driver. I’m not sure whether it is some disease caused by electro cars or perhaps lorry cars syndrome but there is no family car capable of full output at idle engine speeds.

Can I send in my control unit by normal mail? You can send us your control unit by normal mail, and we do the programming directly on your control unit. Please fill in our form to this end and send it to us together with your control unit. Individual tunings for which we have no appropriate data can be carried out only directly on the vehicle. In the case of major hardware conversions, please send us a request by e-mail in advance. How does the chip tuning get to my control unit? It always depends on the vehicle. For older vehicles, before the 2000 model year, the EPROM (memory chip with the engine software) usually must be removed for writing and soldered in again. In the case of vehicles as of the 2000 model year, the optimized software can usually be written onto the engine control unit (flashed) via the OBD interface in the vehicle. Very new vehicles with tuning protection are read out and written with a special method. The control unit is removed and read and written with state-of-the-art BDM and boot pin devices.

Chip tuning car includes adjustments that enhance the execution, the care of, and presentation of a vehicle. Tuning is an approach to customize a car and is a side interest for some. The territories of adjustment incorporate sound, inside, motor, suspension, and body. Every one of these ranges makes an interminable number of particular auto adjustments and can incorporate expanding efficiency, enhancing taking care of, or changing the outside.

Increased Performance: Engine chip tuning can be done to remove limits that are placed on your engine by the manufacturer. This can result in a variety of different results, depending on how you modify the chip. You can gain greater horsepower, and thus a greater top speed and a faster rate of acceleration, or you can prioritize fuel efficiency, helping you save money at the pump over time. See extra details on tuningbox.